SMART KEY SYSTEM (for Start Function) > PRECAUTION |
| 1.PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL |
| System Name | See Procedure |
| Power Door Lock Control System |
Click here
|
| 2.DOOR CONTROL RECEIVER EXPRESSIONS |
The type of door control receiver used on this model differs according to the specifications of the vehicles. The expressions listed in the table below are used in this section.
| Vehicle Specification | Part Name in Manual | Actual Part Name |
| w/ Tire Pressure Warning System | Door control receiver | Door control and tire pressure monitoring system receiver assembly |
| w/o Tire Pressure Warning System | Door control receiver | Door control receiver |
| 3.PRECAUTIONS WHEN USING TECHSTREAM |
When using the Techstream with the power switch off to troubleshoot the smart key system (for Start Function):
Connect the Techstream to the DLC3 and turn a door courtesy light on and off at 1.5-second or less intervals until communication between the Techstream and vehicle begins (the Techstream screen changes when communication begins).
| 4.PRECAUTION FOR REGISTRATION |
If replacing any of the following parts, refer to the registration procedures (Click here).
Certification ECU (smart key ECU assembly)
Steering lock ECU (steering lock actuator assembly)
Electrical key transmitter sub-assembly
ID code box (immobiliser code ECU)