SMART KEY SYSTEM (for Start Function) > DTC CHECK / CLEAR |
| CHECK FOR DTC (POWER MANAGEMENT CONTROL ECU [POWER SOURCE CONTROL]) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Power Source Control / DTC.
Check for DTCs.
| CHECK FOR DTC (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) [SMART KEY]) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Smart Key / DTC.
Check for DTCs.
| CLEAR DTC (POWER MANAGEMENT CONTROL ECU [POWER SOURCE CONTROL]) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Power Source Control / DTC / Clear.
Clear the DTCs by following the directions on the Techstream display.
| CLEAR DTC (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) [SMART KEY]) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Smart Key / DTC / Clear.
Clear the DTCs by following the directions on the Techstream display.