Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM

DTC    P1578    Brake System Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when the electronically controlled brake system has a problem. Check the electronically controlled brake system when this DTC is output.

DTC No.
DTC Detection Condition
Trouble Area
P1578
The power management control ECU receives a brake system error signal for 0.2 sec. or more while the cruise control is in operation
  1. Electronically controlled brake system
  1. Power management control ECU

WIRING DIAGRAM


E149011E55


INSPECTION PROCEDURE

HINT:
This circuit uses CAN communication. Therefore, if there are any malfunctions in the communication circuit, one or more DTCs in the CAN communication system are output.

1.CHECK DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.

  1. Check for the DTC.

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM (Click here)
A


2.CHECK FOR DTCs (DTC P1578)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch ON.

  1. Turn the Techstream on.

  1. Perform the following to make sure that the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the malfunction cannot be detected.

    1. Drive the vehicle at a speed for which cruise control operation is possible.

    2. Turn the cruise control system on using the ON-OFF switch.

    3. Push the -/SET switch to activate the cruise control.

  1. Enter the following menus: Powertrain / Cruise Control / Trouble Codes.

  1. Check for DTCs.

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC P1578 is output
    B



B
Go to step 3
A

USE SIMULATION METHOD TO CHECK (Click here)  

3.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY
Replace the brake booster with master cylinder assembly (skid control ECU) (Click here).

NEXT


4.CHECK FOR DTCs (DTC P1578)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch ON.

  1. Turn the Techstream on.

  1. Clear the DTCs (Click here).

  1. Perform the following to make sure that the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the malfunction cannot be detected.

    1. Drive the vehicle at a speed for which cruise control operation is possible.

    2. Turn the cruise control system on using the ON-OFF switch.

    3. Push the -/SET switch to activate the cruise control.

  1. Enter the following menus: Powertrain / Cruise Control / Trouble Codes.

  1. Check for DTCs.

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC P1578 is output
    B



B
REPLACE POWER MANAGEMENT CONTROL ECU (Click here)
A

END