DTC P0575 Cruise Control Input Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0575 | When both of the following conditions are met:
| Power management control ECU |
| 1.CHECK FOR DTCs (DTC P0575) |
Connect the Techstream to the DLC3.
Turn the ignition switch ON.
Turn the Techstream on.
Clear the DTCs (Click here).
Perform the following to make sure that the DTC detection conditions are met.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control system on using the ON-OFF switch.
Push the -/SET switch to activate the cruise control.
Enter the following menus: Powertrain / Cruise Control / Trouble Codes.
Check for DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC P0575 is output | B |
|
| ||||
| A | ||
| ||