Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION SYSTEM

OCCUPANT CLASSIFICATION SYSTEM > PRECAUTION

for Preparation Click here



1.PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following system(s) after the cable is reconnected:


System
See Procedure
Power Door Lock Control System
Click here

2.IGNITION SWITCH EXPRESSIONS
The type of ignition switch used on this model differs according to the specification of the vehicle.
The expressions listed in the table below are used in this section.

Expression
Ignition Switch (Position)
Power Switch (Condition)
Ignition Switch off
LOCK
Off (Lock)
Ignition Switch ACC
ACC
On (ACC)
Ignition Switch ON (IG)
ON (IG)
On (IG)
Ignition Switch ON (READY)
ON (READY)
On (Ready)

3.GENERAL PRECAUTION
Perform zero point calibration and sensitivity check if any of the following conditions occur:
  1. The occupant detection ECU is replaced.
  2. Accessories (seatback tray and seat cover, etc.) are installed.
  3. The front passenger seat is removed from the vehicle.
  4. One of the bolts that is used to install the front passenger seat is removed and reinstalled.
  5. The vehicle is brought to the workshop for repair due to an accident or a collision.