Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION SYSTEM

OCCUPANT CLASSIFICATION SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Turn the ignition switch off.

  2. Connect the Techstream to the DLC3.

  3. Turn the ignition switch to ON (IG).

  4. Turn the Techstream on.

  5. Enter the following menus: Body Electrical / Occupant Detection / Data List.

  6. Check the values by referring to the table below.

    Occupant Detection 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IG Switch
    ignition switch condition/
    ON: Ignition switch ON (IG)
    OFF: Ignition switch off
    ON/OFF
    -
    Passenger Buckle SW
    Passenger side buckle switch/
    Set: The seat belt is fastened
    Unset: The seat belt is not fastened
    NG: Data is not determined
    Set/Unset
    -
    Passenger Classification
    Passenger classification/
    AM50: Adult is seated. (More than 39 kg (86.0 lb) is detected.)
    AF05: Adult is seated. (17 to 39 kg (37.5 to 86.0 lb) is detected.)
    Child: Child is seated. (Less than 17 kg (37.5 lb) is detected.)
    CRS: Child restraint system is installed. (Less than 16 kg (35.3 lb) is detected and the passenger side buckle switch is on.)
    OFF: Vacant
    AM50/AF05/Child/CRS/OFF
    The weight detected by the system is not always consistent with actual occupant's weight.
    Sensor Range Info
    Sensor range information/
    OK: The value of a sensor is within the range
    NG: The value of a sensor is over the range
    OK
    -
    RL Sensor Range Info
    Rear left sensor range information/
    OK: Sensor range is -10.00 to 30.00 kg (-22.05 to 66.13 lb)
    Min.: Less than -10.00 kg (-22.05 lb)
    Max.: More than 30.00 kg (66.13 lb)
    OK
    -
    RR Sensor Range Info
    Rear right sensor range information/
    OK: Sensor range is -10.00 to 30.00 kg (-22.05 to 66.13 lb)
    Min.: Less than -10.00 kg (-22.05 lb)
    Max.: More than 30.00 kg (66.13 lb)
    OK
    -
    RL Sensor Voltage
    Rear left sensor voltage/
    Min.: 0.000 V
    Max.: 19.800 V
    0.000 to 5.000 V
    -
    RR Sensor Voltage
    Rear right sensor voltage/
    Min.: 0.000 V
    Max.: 19.800 V
    0.000 to 5.000 V
    -
    RL Sensor Weight Info
    Rear left sensor weight information/
    Min.: -10.00 kg (-22.05 lb)
    Max.: 30.00 kg (66.13 lb)
    -10.00 to 30.00 kg
    (-22.05 to 66.13 lb)
    -
    RR Sensor Weight Info
    Rear right sensor weight information/
    Min.: -10.00 kg (-22.05 lb)
    Max.: 30.00 kg (66.13 lb)
    -10.00 to 30.00 kg
    (-22.05 to 66.13 lb)
    -
    Total Weight Information
    Total weight information/
    Min.: -40.00 kg (-88.19 lb)
    Max.: 100.00 kg (220.46 lb)
    -40.00 to 100.00 kg
    (-88.19 to 220.46 lb)
    -
    Number of Present DTC
    Number of present DTC recorded/
    Min.: 0, Max.: 255
    0
    -
    Number of Past DTC
    Number of past DTC recorded/
    Min.: 0, Max.: 255
    0
    -