Home › Vehicle Interior › DOOR LOCK › KEY REMINDER WARNING SYSTEM

KEY REMINDER WARNING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

B281049E05

  1. Disconnect the MB and G59 main body ECU (multiplex network body ECU) connectors.

  2. Measure the resistance and voltage according to the value(s) in the table below.

    HINT:
    Measure the values on the wire harness side with the connector disconnected.


    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    MB-11 (GND1) - Body ground
    -
    Ground
    Always
    Below 1 Ω
    MB-2 (FLCY) - Body ground
    -
    Driver door courtesy light switch input
    Driver door open
    Below 1 Ω
    MB-2 (FLCY) - Body ground
    -
    Driver door courtesy light switch input
    Driver door closed
    10 kΩ or higher
    G59-17 (KSW) - Body ground
    V - Body ground
    Unlock warning switch signal
    No key in ignition key cylinder
    10 kΩ or higher
    G59-17 (KSW) - Body ground
    V - Body ground
    Unlock warning switch signal
    Key in ignition key cylinder
    Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.