Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION ECU

OCCUPANT CLASSIFICATION ECU > INSTALLATION

for Preparation Click here



1. INSTALL OCCUPANT DETECTION ECU
  1. Engage the claw to install the occupant detection ECU.

    NOTICE:
    If the occupant detection ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant detection ECU with a new one.

  1. Connect the 2 connectors.

    NOTICE:
    When installing the occupant detection ECU, be careful that the SRS wiring does not interfere with or is pinched between other parts.



2. INSTALL FRONT SEAT ASSEMBLY RH

HINT:
Use the same procedure for the RH side and LH side.
  1. w/ Non-removable Headrest: (Click here)
  2. w/ Removable Headrest: (Click here)



3. PERFORM DIAGNOSTIC SYSTEM CHECK
(Click here)


4. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK
(Click here)