Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY

FRONT SEAT INNER BELT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH (w/ Seat Heater System)


    B307009E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    M14-3 - B-1
    Always
    Below 1 Ω
    M14-4 - B-2
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Front Seat Inner Belt Assembly LH)
    If the result is not as specified, replace the front seat inner belt assembly LH.