SEAT BELT WARNING SYSTEM > DATA LIST / ACTIVE TEST |
| DATA LIST |
Connect the Techstream to the DLC3.
Turn the ignition switch ON (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter, Occupant Detection or SRS Airbag / Data List.
Read the Data List according to the display on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Driver Side Seatbelt Warning Buzzer | Driver seat belt warning buzzer/ON or OFF | Customized value displayed | - |
| P-Seatbelt Warning Buzzer | Front passenger seat belt warning buzzer/ON or OFF | Customized value displayed | - |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Passenger Buckle SW | Front passenger buckle switch/Set, Unset or NG | Set: Seat belt fastened Unset: Seat belt not fastened NG: Data not determined | - |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Left side Buckle SW | LH buckle switch/Unset, Set or NG | Unset: Seat belt not fastened Set: Seat belt fastened NG: Data not determined | - |
| Right side Buckle SW | RH buckle switch/Unset, Set or NG | Unset: Seat belt not fastened Set: Seat belt fastened NG: Data not determined | - |
| ACTIVE TEST |
Connect the Techstream to the DLC3.
Turn the ignition switch ON (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Perform the Active Test according to the display on the Techstream.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Driver Side Seat Belt | Seat belt warning light | OFF/ON | - |