Home › Vehicle Interior › SEAT › SEAT HEATER SWITCH

SEAT HEATER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT SEAT HEATER SWITCH


  1. Check the seat heater switch.



      B231438E01
    1. Measure the resistance according to the value(s) in the table below.
      Text in Illustration 
      *a
      Component without harness connected
      (Seat Heater Switch)

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      5 - 6
      Seat heater switch (for LH) on
      Below 1 Ω
      5 - 6
      Seat heater switch (for LH) off
      10 kΩ or higher
      4 - 3
      Seat heater switch (for RH) on
      Below 1 Ω
      4 - 3
      Seat heater switch (for RH) off
      10 kΩ or higher

      If the result is not as specified, replace the seat heater switch.

  1. Check that the LED illuminates.

    1. Apply auxiliary battery voltage to the seat heater switch and check that the LED illuminates.
      Text in Illustration 
      *a
      Component without harness connected
      (Seat Heater Switch)

      OK:
      Measurement Condition
      Condition
      Specified Condition
      Auxiliary battery positive (+) → Terminal 5
      Auxiliary battery negative (-) → Terminal 2
      Seat heater switch (for LH) on
      LED illuminates
      (Yellow)
      Auxiliary battery positive (+) → Terminal 4
      Auxiliary battery negative (-) → Terminal 2
      Seat heater switch (for RH) on
      LED illuminates
      (Yellow)
      Auxiliary battery positive (+) → Terminal 7
      Auxiliary battery negative (-) → Terminal 8
      Always
      LED illuminates
      (Greenish white)

      If the result is not as specified, replace the seat heater switch.