Home › Engine / Hybrid System › 1NZ-FXE STARTING › IGNITION SWITCH

IGNITION SWITCH > INSPECTION

for Preparation Click here



1. INSPECT IGNITION OR STARTER SWITCH ASSEMBLY


    A247262E02
  1. Measure the switch resistance.
    Text in Illustration 
    *a
    Component without harness connected
    (Ignition or Starter Switch Assembly)
    *b
    LOCK
    *c
    ACC
    *d
    ON
    *e
    START

    Standard Resistance:
    Tester Connection
    Switch Position
    Specified Condition
    Between all terminals
    LOCK
    10 kΩ or higher
    2 (ACC) - 4 (AM1)
    ACC
    Below 1 Ω
    2 (ACC) - 4 (AM1)
    ON
    1 (IG1) - 4 (AM1)
    5 (AM2) - 6 (IG2)
    3 (ST1) - 4 (AM1)
    START
    1 (IG1) - 4 (AM1)
    5 (AM2) - 6 (IG2)
    5 (AM2) - 7 (ST2)

    If the result is not as specified, replace the ignition or starter switch assembly.