Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › ACCELERATOR PEDAL SENSOR

ACCELERATOR PEDAL SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY

NOTICE:
  1. Avoid physical shock to the accelerator pedal sensor assembly.
  2. Do not disassemble the accelerator pedal sensor assembly.
  3. This accelerator pedal sensor assembly does not require lubrication.
  4. Do not apply oil or other lubrication to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.

  1. Install the accelerator pedal sensor assembly with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the accelerator pedal sensor assembly connector.