Home › Engine / Hybrid System › 1NZ-FXE ENGINE CONTROL › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > INSPECTION

for Preparation Click here



1. INSPECT CAM POSITION SENSOR
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Cold
    1630 to 2740 Ω
    Hot
    2065 to 3225 Ω

    HINT:
    In the table above, the terms Cold and Hot refer to the temperature of the coils. Cold means approximately -10 to 50°C (14 to 122°F). Hot means approximately 50 to 100°C (122 to 212°F).

    If the resistance is not as specified, replace the cam position sensor.