Home › Vehicle Interior › METER / GAUGE / DISPLAY › LIGHT CONTROL RHEOSTAT

LIGHT CONTROL RHEOSTAT > INSPECTION

for Preparation Click here



1. INSPECT LIGHT CONTROL RHEOSTAT


    E249139E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (E) - 3 (TR)
    Light control rheostat is fully turned downwards (MIN.)
    Below 50 Ω
    1 (E) - 3 (TR)
    Light control rheostat position is between MIN. and MAX.
    The value changes gradually (Between 0 to 12 kΩ
    1 (E) - 3 (TR)
    Light control rheostat is fully turned upwards (MAX.)
    8 to 12 kΩ
    5 (TC) - 7 (T)
    Light control rheostat position is not fully turned upwards (Tail cancel switch is off)
    Below 50 Ω
    5 (TC) - 7 (T)
    Light control rheostat is fully turned upwards (Tail cancel switch is on)
    8 to 12 kΩ

    Text in Illustration 
    *a
    Component without harness connected
    (Light Control Rheostat)
    If the value is not as specified, replace the light control rheostat.