Terminals No. (Symbol)
| Wiring Color
| Terminal Description
| Condition
| Specified Condition
|
G6-1 (IG) - Body ground
| L - Body ground
| IG power source
| Ignition switch ON (IG)
| 9 to 16 V
|
G6-6 (TS) - Body ground
| G - Body ground
| Test mode signal
| Always
| 9 to 16 V
|
G6-7 (CANH) - G6-8 (CANL)
| LG - W
| CAN communication line
| Ignition switch off
| 54 to 69 Ω
|
z7-1 (TRQ2) - Body ground
| Y - Body ground
| Torque sensor 2 input signal
| Ignition switch ON (READY), steering wheel not being turned (without load)
| 2.3 to 2.7 V
|
Ignition switch ON (READY), steering wheel being turned to right
| 1.2 to 2.5 V
|
Ignition switch ON (READY), steering wheel being turned to left
| 2.5 to 3.8 V
|
z7-2 (TRQG) - Body ground
| B - Body ground
| Torque sensor ground
| Always
| Below 1 Ω
|
z7-8 (TRQV) - Body ground
| R - Body ground
| Torque sensor power source
| Ignition switch ON (READY)
| 4.5 to 5.5 V
|
z7-9 (TRQ1) - Body ground
| W - Body ground
| Torque sensor 1 input signal
| Ignition switch ON (READY), steering wheel not being turned (without load)
| 2.3 to 2.7 V
|
Ignition switch ON (READY), steering wheel being turned to right
| 2.5 to 3.8 V
|
Ignition switch ON (READY), steering wheel being turned to left
| 1.2 to 2.5 V
|
z8-1 (M1) - Body ground
| R - Body ground
| Power steering motor assembly output signal 1
| Ignition switch ON (READY), steering wheel being turned to left
| 9 to 16 V
|
Ignition switch ON (READY), steering wheel being turned to right
| 6 to 8 V
|
z8-2 (M2) - Body ground
| B - Body ground
| Power steering motor assembly output signal 2
| Ignition switch ON (READY), steering wheel being turned to left
| 6 to 8 V
|
Ignition switch ON (READY), steering wheel being turned to right
| 9 to 16 V
|
A33-1 (PIG) - Body ground
| W - Body ground
| Power steering motor assembly power supply input signal
| Always
| 9 to 16 V
|
A33-2 (PGND) - Body ground
| W-B - Body ground
| Power ground
| Always
| Below 1 Ω
|