Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1524/24    Motor Circuit Malfunction

DTC    C1555/55    Predriver Malfunction

for Preparation Click here


DESCRIPTION

The power steering ECU assembly supplies current to the power steering motor assembly through the motor circuit.

DTC No.
DTC Detection Condition
Trouble Area
C1524/24
Short (or open) in motor circuit or abnormal voltage in motor circuit
  1. Power steering motor assembly
  2. Power steering ECU assembly
C1555/55
Predriver (Motor relay circuit) malfunction

WIRING DIAGRAM


C250218E03


INSPECTION PROCEDURE

NOTICE:
If the power steering ECU assembly has been replaced with a new one, perform assist map writing and torque sensor zero point calibration (Click here).

HINT:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK POWER STEERING ECU ASSEMBLY
C240098E04
  1. Turn the ignition switch on to ON (READY).

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    (Steering Wheel Position)
    Specified Condition
    z8-1 (M1) - Body ground
    Ignition switch ON (READY)
    (Turned to right)
    6 to 8V
    z8-1 (M1) - Body ground
    Ignition switch ON (READY)
    (Turned to left)
    9 to 16 V
    z8-2 (M2) - Body ground
    Ignition switch ON (READY)
    (Turned to right)
    9 to 16 V
    z8-2 (M2) - Body ground
    Ignition switch ON (READY)
    (Turned to left)
    6 to 8V

    Text in Illustration 
    *a
    Component with harness connected
    (Power Steering ECU Assembly)



NG
REPLACE POWER STEERING ECU ASSEMBLY (Click here)
OK


2.CHECK POWER STEERING MOTOR ASSEMBLY
C250545E02
  1. Disconnect the connector from the power steering ECU assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    z8-1 (M1) - z8-2 (M2)
    Always
    0.08 to 0.15 Ω
    z8-1 (M1) - Body ground
    Always
    1 MΩ or higher
    z8-2 (M2) - Body ground
    Always
    1 MΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Power Steering ECU Assembly)



NG
REPLACE POWER STEERING MOTOR ASSEMBLY
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)