Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR

REAR SPEED SENSOR > REMOVAL

for Preparation Click here


NOTICE:
  1. When the brake pedal is first depressed after replacing the brake pads, pushing back the disc brake piston or wheel cylinder piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.
  2. While the auxiliary battery is connected, even if the ignition switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch is turned on. Therefore, even if only brake shoes are to be removed and installed, be sure to perform the Disable Brake Control procedure and disconnect the cable from the negative (-) terminal of the auxiliary battery before beginning work.

HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The following procedure is for the LH side.
  3. If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.
  4. The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor malfunctions, replace the rear axle hub and bearing assembly.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (Click here).



2. DISABLE BRAKE CONTROL
  1. Wait at least 2 minutes after turning the ignition switch off.

    NOTICE:
    When the brake pedal is depressed or the door courtesy switch is turned on even if the ignition switch is off, the brake control system activates. Therefore do not depress the brake pedal or open/close the doors until the reservoir level switch connector is disconnected.



    C250008
  1. Disconnect the reservoir level switch connector with the parking brake applied.

  1. Disconnect the cable from the negative (-) auxiliary battery terminal (Click here).

  1. Depress the brake pedal 40 times or more to return all the fluid in the accumulator back to the reservoir.

  1. Check that the brake pedal can not be further depressed.

  1. Release the parking brake.



3. REMOVE REAR WHEEL


4. DISCONNECT SKID CONTROL SENSOR WIRE


    C249819
  1. Disengage the 3 claws and remove the connector cover.



    C249820
  1. Disconnect the skid control sensor wire connector from the rear axle hub and bearing assembly.



5. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY


    C233134
  1. Release the parking brake and remove the rear brake drum sub-assembly.
    Text in Illustration 
    V100135
    Contract

    HINT:
    If the rear brake drum sub-assembly cannot be removed easily, perform the following procedure.


    1. Remove the shoe adjusting hole plug and insert a screwdriver through the hole into the backing plate, and hold the automatic adjust lever away from the adjuster.

    2. Using another screwdriver, contract the brake shoe by turning the adjusting bolt.



6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
  1. Remove the rear axle hub and bearing assembly .

    HINT:
    1. The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor malfunctions, replace the rear axle hub and bearing assembly.
    2. If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.