Home › Brake › PARKING BRAKE › PARKING BRAKE SYSTEM

PARKING BRAKE SYSTEM > ADJUSTMENT

for Preparation Click here



1. ADJUST REAR DRUM BRAKE SHOE CLEARANCE


    C151749
  1. Temporarily install the 2 wheel nuts.
    Text in Illustration 
    V100135
    Expand

  1. Remove the shoe adjusting hole plug, and turn the adjuster to expand the shoe until the drum locks.



    C233134E03
  1. Hold the automatic adjust lever away from the adjuster, and contract the brake shoe by turning the adjust bolt using another screwdriver until the drum can rotate smoothly.
    Text in Illustration 
    *1
    Automatic Adjust Lever
    V100135
    Contract

  1. Install the hole plug.



2. INSPECT PARKING BRAKE LEVER TRAVEL
  1. Firmly pull the parking brake lever.

  1. Release the parking brake lever lock and return it to its off position.



    C247539
  1. Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.

    Parking brake lever travel:
    8 to 11 notches at 200 N (20 kgf, 45.0 lbf)

    If the parking brake lever travel is not as specified, adjust the parking brake lever travel.



3. ADJUST PARKING BRAKE LEVER TRAVEL
  1. Release the parking brake lever lock and return it to its off position.

  1. Remove the rear console box (Click here).

  1. w/ Console Box Lid:

    1. Remove the No. 1 console box mounting bracket .

    2. Remove the No. 3 console box mounting bracket .



    C247540E01
  1. Turn the lock nut until the parking brake lever travel is corrected to within the specified range.
    Text in Illustration 
    *1
    Lock nut

    Parking brake lever travel:
    8 to 11 notches at 200 N (20 kgf, 45.0 lbf)

    NOTICE:
    If the lock nut has been removed from the rod, replace the lock nut with a new one.

  1. Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.

  1. Check that the parking brake does not drag.

  1. w/ Console Box Lid:

    1. Install the No. 3 console box mounting bracket .

    2. Install the No. 1 console box mounting bracket .

  1. Install the rear console box (Click here).



4. INSPECT BRAKE WARNING LIGHT
  1. When operating the parking brake lever, check that the brake warning light illuminates.

    Standard:
    The brake warning light always illuminates at the first click.