Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1531/31    EPS ECU Circuit Malfunction

DTC    C1532/32    EPS ECU Circuit Malfunction

DTC    C1533/33    EPS ECU Circuit Malfunction

DTC    C1534/34    EPS ECU Circuit Malfunction

DTC    C1535/35    Steering Wheel Location Data Error

for Preparation Click here


DESCRIPTION

The fail-safe function operates to stop power assist when DTCs indicating ECU malfunctions are stored. However, power assist operation continues when DTC C1533/33 or C1534/34 is stored because it indicates an EEPROM error in the ECU.

DTC No.
DTC Detection Condition
Trouble Area
C1531/31
ECU internal malfunction (CPU malfunction)
Power steering ECU assembly
C1532/32
ECU internal malfunction (Peripheral circuit malfunction)
C1533/33
ECU internal malfunction (Substrate temperature sensor malfunction)
C1534/34
ECU internal malfunction (EEPROM error)
C1535/35
ECU internal malfunction (Steering wheel location data error)

INSPECTION PROCEDURE

NOTICE:
If the power steering ECU assembly has been replaced with a new one, perform assist map writing and torque sensor zero point calibration (Click here).

1.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTCs other than C1531/31, C1532/32, C1533/33, C1534/34 and C1535/35 are not output.



NG
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (Click here)
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)