Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1551/51    IG Power Supply Voltage Malfunction

for Preparation Click here


DESCRIPTION

The power steering ECU assembly distinguishes the ignition switch status as ON (IG) or off through the IG power source circuit.

DTC No.
DTC Detection Condition
Trouble Area
C1551/51
Open or short in IG power source circuit with ignition switch ON
  1. ECU-IG No. 2 fuse
  2. IG power source circuit
  3. Power steering ECU assembly

WIRING DIAGRAM


C113532E47


INSPECTION PROCEDURE

NOTICE:
If the power steering ECU assembly has been replaced with a new one, perform assist map writing and the torque sensor zero point calibration (Click here).

HINT:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.READ VALUE USING TECHSTREAM (IG POWER SUPPLY)
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON (IG).

  1. Turn the Techstream on.

  1. Enter the following menus: Chassis / EMPS / Data List.

  1. Select the item "IG power supply" in the Data List and read the value displayed on the Techstream.

    EMPS 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IG power supply
    IG power supply/
    Min.: 0.0000 V
    Max.: 20.1531 V
    9 to 16 V
    Ignition switch ON (IG)

    OK:
    The normal condition value is displayed on the Techstream.



NG
Go to step 2
OK

CHECK INTERMITTENT PROBLEMS 

2.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU ASSEMBLY - BODY GROUND)


    C250087E03
  1. Disconnect the connectors from the power steering ECU assembly.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    G6-1 (IG) - Body ground
    Ignition switch ON (IG)
    9 to 16 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A33-2 (PGND) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Power Steering ECU Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)