DTC C1552/52 DC Motor Power Source Voltage Malfunction |
DTC C1554/54 EPS Relay Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1552/52 | PIG power source circuit malfunction |
|
| C1554/54 | Power source relay circuit malfunction |
|

| 1.READ VALUE USING TECHSTREAM |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Turn the Techstream on.
Enter the following menus: Chassis / EMPS / Data List.
Select the item "PIG power supply" in the Data List and read the value displayed on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| PIG Power Supply | Power source voltage to activate motor/ Min.: 0.0000 V Max.: 20.1531 V | 9 to 16 V | Always |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (AUXILIARY BATTERY - POWER STEERING ECU ASSEMBLY - BODY GROUND) |
![]() |
Disconnect the connector from the power steering ECU assembly.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A33-1 (PIG) - Body ground | Always | 9 to 16 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A33-2 (PGND) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Power Steering ECU Assembly) |
|
| ||||
| OK | ||
| ||