Home › Engine / Hybrid System › 1NZ-FXE ENGINE CONTROL › INTEGRATION RELAY

INTEGRATION RELAY > INSPECTION

for Preparation Click here



1. INSPECT NO. 1 INTEGRATION RELAY



A267849E04


Text in Illustration 
*1
No. 1 Integration Relay
-
-


  1. EFI-MAIN Relay:



      A095606E26
    1. Measure the resistance according to the value(s) in the table below.
      Text in Illustration 
      *1
      No. 1 Integration Relay

      Standard Resistance:

      Tester Connection
      Condition
      Specified Condition
      No. 1 Integration relay (2E-1) - No. 1 Integration relay (2C-4)
      Auxiliary battery voltage is not applied between terminals 2C-3 and 2C-2
      10 kΩ or higher
      No. 1 Integration relay (2E-1) - No. 1 Integration relay (2C-4)
      Auxiliary battery voltage is applied between terminals 2C-3 and 2C-2
      Below 1 Ω

      If the resistance is not as specified, replace the No. 1 integration relay.



  1. HORN Relay:



      A095606E26
    1. Measure the resistance according to the value(s) in the table below.
      Text in Illustration 
      *1
      No. 1 Integration Relay

      Standard Resistance:

      Tester Connection
      Condition
      Specified Condition
      No. 1 Integration relay (2E-1) - No. 1 Integration relay (2C-8)
      Auxiliary battery voltage is not applied between terminals 2C-6 and 2C-7
      10 kΩ or higher
      No. 1 Integration relay (2E-1) - No. 1 Integration relay (2C-8)
      Auxiliary battery voltage is applied between terminals 2C-6 and 2C-7
      Below 1 Ω

      If the resistance is not as specified, replace the No. 1 integration relay.



  1. IG2 Relay:



      A095606E26
    1. Measure the resistance according to the value(s) in the table below.
      Text in Illustration 
      *1
      No. 1 Integration Relay

      Standard Resistance:

      Tester Connection
      Condition
      Specified Condition
      No. 1 Integration relay (2E-1) - No. 1 Integration relay (2D-4)
      Auxiliary battery voltage is not applied between terminals 2D-2 and 2D-3
      10 kΩ or higher
      No. 1 Integration relay (2E-1) - No. 1 Integration relay (2D-4)
      Auxiliary battery voltage is applied between terminals 2D-2 and 2D-3
      Below 1 Ω

      If the resistance is not as specified, replace the No. 1 integration relay.



  1. C/OPN Relay:



      A095606E26
    1. Measure the resistance according to the value(s) in the table below.
      Text in Illustration 
      *1
      No. 1 Integration Relay

      Standard Resistance:

      Tester Connection
      Condition
      Specified Condition
      No. 1 Integration relay (2D-5) - No. 1 Integration relay (2D-8)
      Auxiliary battery voltage is not applied between terminals 2D-6 and 2D-7
      10 kΩ or higher
      No. 1 Integration relay (2D-5) - No. 1 Integration relay (2D-8)
      Auxiliary battery voltage is applied between terminals 2D-6 and 2D-7
      Below 1 Ω

      If the resistance is not as specified, replace the No. 1 integration relay.