ECM > INSTALLATION |
| 1. INSTALL ECM |
Install the ECM cover and No. 2 ECM bracket with the 4 screws.
Install the nut.
Install the ECM with the bolt and nut.
![]() |
Connect the 2 ECM connectors and lower the 2 levers.
| 2. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY |
![]() |
Install the outer cowl top panel sub-assembly with the 8 bolts and nut.
Engage the clamp to install the wire harness.
| 3. INSTALL FRONT NO. 1 VENTILATOR SEAL |
Engage the clamp to install the front No. 1 ventilator seal to the outer cowl top panel sub-assembly.
| 4. INSTALL FRONT AIR SHUTTER SEAL |
Engage the clamp to install the front air shutter seal to the outer cowl top panel sub-assembly.
| 5. INSTALL INNER COWL TOP TO COWL BRACE |
![]() |
Install the inner cowl top to cowl brace to the outer cowl top panel sub-assembly with the 3 bolts.
| 6. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY |
| 7. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL |
| 8. INSTALL FRONT FLOOR COVER RH |
Engage the 3 guides.
![]() |
Engage the 3 clips <B> to install the front floor cover RH.
Install the 2 clips <A>.
| 9. PERFORM INITIALIZATION |
Perform Initialization when replacing the ECM .