CYLINDER BLOCK > DISASSEMBLY |
| 1. INSPECT CONNECTING ROD THRUST CLEARANCE |
![]() |
Using a dial indicator, measure the thrust clearance while moving the connecting rod back and forth.
| 2. INSPECT CRANKSHAFT THRUST CLEARANCE |
![]() |
Using a dial indicator, measure the thrust clearance while prying the crankshaft back and forth with a screwdriver.
| Item | Thrust Washer Thickness | Thrust Clearance |
| STD | 2.43 to 2.48 mm (0.0957 to 0.0976 in.) | 0.04 to 0.24 mm (0.00157 to 0.00945 in.) |
| O/S 0.125 | 2.493 to 2.543 (0.0981 to 0.100 in.) | 0.04 to 0.24 mm (0.00157 to 0.00945 in.) |
| O/S 0.250 | 2.555 to 2.605 (0.101 to 0.103 in.) | 0.04 to 0.24 mm (0.00157 to 0.00945 in.) |
| 3. REMOVE PISTON SUB-ASSEMBLY WITH CONNECTING ROD |
![]() |
Using a ridge reamer, remove all carbon from the top of the cylinder.
Mark each cylinder No. on the connecting rod and connecting rod cap with paint.
![]() |
Using SST, remove the 2 connecting rod cap bolts.
![]() |
Using the 2 removed connecting rod cap bolts, remove the connecting rod cap with connecting rod bearing by wiggling the connecting rod cap right and left.
Clean the crank pin and connecting rod bearing.
Push the piston, connecting rod and connecting rod bearing through the top of the cylinder block.
| 4. REMOVE CONNECTING ROD BEARING |
Remove the 8 connecting rod bearings.
| 5. REMOVE PISTON RING SET |
![]() |
Using a piston ring expander, remove the No. 1 compression ring and No. 2 compression ring.
Remove the oil ring and oil ring expander by hand.
| 6. REMOVE PISTON SUB-ASSEMBLY WITH PISTON PIN |
![]() |
Using SST, press out the piston pin from the piston.
| 7. REMOVE CRANKSHAFT |
![]() |
Using several steps, uniformly loosen and remove the 10 crankshaft bearing cap bolts with a 12 mm socket wrench for 12 pointed head in the sequence shown in the illustration.
![]() |
Using the 2 removed crankshaft bearing cap bolts, remove the 5 crankshaft bearing caps.
![]() |
Remove the crankshaft from the cylinder block.
| 8. REMOVE UPPER CRANKSHAFT THRUST WASHER |
![]() |
Remove the 2 upper crankshaft thrust washers from the cylinder block.
| 9. REMOVE CRANKSHAFT BEARING |
![]() |
Remove the 5 upper crankshaft bearings from the cylinder block.
![]() |
Remove the 5 lower crankshaft bearings from the crankshaft bearing cap.
| 10. REMOVE WATER BY-PASS HOSE UNION |
![]() |
Using a 17 mm deep socket wrench, remove the water by-pass hose union from the cylinder block.
| 11. REMOVE OIL JET |
![]() |
Remove the oil jet from the cylinder block.