Home › Engine / Hybrid System › 1NZ-FXE ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > DISASSEMBLY

for Preparation Click here



1. REMOVE TAPER SCREW PLUG


    A088717E02
  1. Using a 10 mm hexagon wrench, remove the taper screw plug and gasket.

    HINT:
    If water leaks from the taper screw plug or the plug is corroded, replace it.



2. REMOVE OIL CONTROL VALVE FILTER


    A038128E02
  1. Using an 8 mm hexagon wrench, remove the straight screw plug.

    HINT:
    If water leaks from the straight screw plug or the plug is corroded, replace it.

  1. Remove the oil control valve filter and gasket.



3. REMOVE VALVE LIFTER


    A088718E02
  1. Remove the 16 valve lifters.

    HINT:
    Arrange the valve lifters in the correct order.



4. REMOVE INTAKE VALVE


    A265772E01
  1. Using SST and wooden blocks, remove the 16 retainer locks.

    SST
    09202-70020   (09202-00010, 09202-01010, 09202-01020)

    HINT:
    Arrange the removed parts in the correct order.

  1. Remove the 8 retainers, 8 compression springs and 8 intake valves.

    HINT:
    Arrange the removed parts in the correct order.



5. REMOVE EXHAUST VALVE


    A265773E01
  1. Using SST and wooden blocks, remove the 16 retainer locks.

    SST
    09202-70020   (09202-00010, 09202-01010, 09202-01020)

    HINT:
    Arrange the removed parts in the correct order.

  1. Remove the 8 retainers, 8 compression springs and 8 exhaust valves.

    HINT:
    Arrange the removed parts in the correct order.



6. REMOVE VALVE STEM OIL SEAL


    A080961E01
  1. Using needle-nose pliers, remove the 16 valve stem oil seals.



7. REMOVE VALVE SPRING SEAT


    A080962E01
  1. Using compressed air and a Magnet Hand, remove the 16 valve spring seats by blowing air onto them.