CYLINDER HEAD > REASSEMBLY |
| 1. INSTALL VALVE SPRING SEAT |
Install the 16 valve spring seats to the cylinder head sub-assembly.
| 2. INSTALL VALVE STEM OIL SEAL |
![]() |
Apply a light coat of engine oil to a new valve stem oil seal.
| *a | Intake Side |
| *b | Exhaust Side |
| *c | Gray |
| *d | Black |
![]() |
Using SST, push on the 16 valve stem oil seals.
| *a | CORRECT |
| *b | INCORRECT |
| 3. INSTALL INTAKE VALVE |
![]() |
Sufficiently apply engine oil to the tip area of the intake valve shown in the illustration.
| *a | 30 mm (1.18 in.) or more |
Install the 8 intake valves, 8 compression springs and 8 retainers to the cylinder head sub-assembly.
![]() |
Using SST and wooden blocks, compress the compression spring and install the 8 retainer locks.
![]() |
Using a pin punch and plastic hammer, lightly tap the valve stem tip to ensure a proper fit.
| 4. INSTALL EXHAUST VALVE |
![]() |
Sufficiently apply engine oil to the tip area of the exhaust valve shown in the illustration.
| *a | 30 mm (1.18 in.) or more |
Install the 8 exhaust valves, 8 compression springs and 8 retainers to the cylinder head sub-assembly.
![]() |
Using SST and wooden blocks, compress the compression spring and install the 8 retainer locks.
![]() |
Using a pin punch and plastic hammer, lightly tap the valve stem tip to ensure a proper fit.
| 5. INSTALL VALVE LIFTER |
Apply a light coat of engine oil to the valve lifters.
![]() |
Install the 16 valve lifters.
Check that the valve lifters rotate smoothly by hand.
| 6. INSTALL OIL CONTROL VALVE FILTER |
Check that no foreign matter is on the mesh part of the oil control valve filter.
![]() |
Using an 8 mm hexagon wrench, install the oil control valve filter with a new gasket and the straight screw plug.
| *a | Mesh Part |
| 7. INSTALL TAPER SCREW PLUG |
Install a new gasket to the taper screw plug.
![]() |
Using a 10 mm hexagon wrench, install the taper screw plug.