Home › Engine / Hybrid System › 1NZ-FXE ENGINE MECHANICAL › CYLINDER BLOCK

CYLINDER BLOCK > REPLACEMENT

for Preparation Click here



1. REPLACE STUD BOLT

HINT:
If any of the stud bolts is deformed or the threads are damaged, replace it.



    A275766E01
  1. Using an E8 "TORX" socket wrench, replace the stud bolts.
    Text in Illustration 
    *a
    12.0 mm (0.472 in.)
    *b
    52.0 mm (2.05 in.)

    Torque:
    6.5 N*m{ 66 kgf*cm , 58 in.*lbf }



2. REPLACE RING PIN

HINT:
If a ring pin is deformed or the threads are damaged, replace it.

  1. Remove the ring pins.



    A265801E01
  1. Using a plastic hammer, tap in the ring pins to the specified protrusion height.
    Text in Illustration 
    *a
    8.0 mm (0.315 in.)
    *b
    3.5 to 4.5 mm (0.138 to 0.177in.)



3. REPLACE STRAIGHT PIN

HINT:
If a straight pin is deformed or the threads are damaged, replace it.

  1. Remove the straight pins.



  1. Using a plastic hammer, tap in the straight pins to the specified protrusion height.


    A268103E01


    Text in Illustration 
    *a
    Timing Chain Cover Side
    *b
    Hybrid Vehicle Transaxle Side
    *c
    Cylinder Head Side
    *d
    Oil Pan Side
    *e
    36.0 mm (1.42 in.)
    *f
    10.0 mm (0.394 in.)
    *g
    18.5 to 19.5 mm (0.728 to 0.768 in.)
    *h
    22.0 mm (0.866 in.)
    *i
    11.5 to 12.5 mm (0.453 to 0.492 in.)
    *j
    18.0 mm (0.709 in.)
    *k
    8.0 mm (0.315 in.)
    *l
    8.5 to 9.5 mm (0.335 to 0.374 in.)