Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK

FRONT DOOR LOCK > INSPECTION

for Preparation Click here



1. INSPECT FRONT DOOR LOCK ASSEMBLY LH


    B171377E23
  1. Check the operation of the front door lock motor.

    1. Apply auxiliary battery voltage and check the operation of the front door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Auxiliary battery positive (+) → 4 (L)
      Auxiliary battery negative (-) → 1 (UL)
      Locks
      Auxiliary battery positive (+) → 1 (UL)
      Auxiliary battery negative (-) → 4 (L)
      Unlocks

      Text in Illustration 
      *a
      Component without harness connected
      (Front Door Lock Assembly LH)
      *b
      Unlock
      *c
      Lock
      If the result is not as specified, replace the front door lock assembly LH.



    B171377E23
  1. Check the resistance of the unlock detection switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      7 (E) - 8 (LSSR)
      Locked
      10 kΩ or higher
      Unlocked
      Below 1 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (Front Door Lock Assembly LH)
      *b
      Unlock
      *c
      Lock
      If the result is not as specified, replace the front door lock assembly LH.



    B164389E21
  1. Check the resistance of the door lock and unlock switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      7 (E) - 9 (L)
      Turned to lock
      Below 1 Ω
      Not turned
      10 kΩ or higher
      7 (E) - 10 (UL)
      Turned to unlock
      10 kΩ or higher
      Not turned
      Below 1 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (Front Door Lock Assembly LH)
      *b
      Unlock
      *c
      Lock
      If the result is not as specified, replace the front door lock assembly LH.



2. INSPECT FRONT DOOR LOCK ASSEMBLY RH


    B171378E25
  1. Check the operation of the front door lock motor.

    1. Apply auxiliary battery voltage and check the operation of the front door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Auxiliary battery positive (+) → 4 (L)
      Auxiliary battery negative (-) → 1 (UL)
      Locks
      Auxiliary battery positive (+) → 1 (UL)
      Auxiliary battery negative (-) → 4 (L)
      Unlocks

      Text in Illustration 
      *a
      Component without harness connected
      (Front Door Lock Assembly RH)
      *b
      Unlock
      *c
      Lock
      If the result is not as specified, replace the front door lock assembly RH.



    B171378E25
  1. Check the resistance of the unlock detection switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      7 (LSSR) - 8 (E)
      Locked
      10 kΩ or higher
      Unlocked
      Below 1 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (Front Door Lock Assembly RH)
      *b
      Unlock
      *c
      Lock
      If the result is not as specified, replace the front door lock assembly RH.