Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF HOUSING

SLIDING ROOF HOUSING > DISASSEMBLY

for Preparation Click here



1. REMOVE SLIDING ROOF DRIVE GEAR ASSEMBLY


    B300924E01
  1. Disengage the claw.
    Text in Illustration 
    *1
    Guide
    *2
    Pin

  1. Disengage the guide and pin, and remove the map light bracket.



    B300925
  1. Remove the 2 bolts and sliding roof drive gear assembly.



2. REMOVE SUNSHADE TRIM SUB-ASSEMBLY


    B300926
  1. Remove the screw and sliding roof piece sub-assembly LH.

    HINT:
    Use the same procedure for the RH side.



    B300927
  1. Slide and remove the sunshade trim sub-assembly.



3. REMOVE REAR ROOF DRIP CHANNEL


    B300929E01
  1. Using a screwdriver, disengage the 2 claws in the direction indicated by the arrow (1) in the illustration.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.

  1. Then slide the rear roof drip channel in the direction indicated by the arrow (2) in the illustration to remove it.



4. REMOVE SLIDING ROOF DRIVE CABLE LH

NOTICE:
Do not disassemble the sliding roof drive cable LH except when replacing it.



    B300933
  1. Hold down the roof wind deflector panel sub-assembly.



    B300931E01
  1. Using a screwdriver, slide the sliding roof drive cable LH in the direction indicated by the arrow in the illustration to remove it.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE SLIDING ROOF DRIVE CABLE RH

HINT:
Use the same procedure as for the LH side.



6. REMOVE ROOF WIND DEFLECTOR PANEL SUB-ASSEMBLY


    B300935E01
  1. Using a screwdriver, turn the screwdriver in the direction indicated by the arrow (1) in the illustration to disengage the 2 springs.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Spring
    *3
    Guide

    HINT:
    Tape the screwdriver tip before use.

  1. Pull the roof wind deflector panel sub-assembly in the direction indicated by the arrow (2) in the illustration to disengage the 2 guides and remove it.