Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF HOUSING

SLIDING ROOF HOUSING > REASSEMBLY

for Preparation Click here



1. INSTALL ROOF WIND DEFLECTOR PANEL SUB-ASSEMBLY


    B300936E01
  1. Engage the 2 guides in the direction indicated by the arrow (1) in the illustration to install the roof wind deflector panel sub-assembly.
    Text in Illustration 
    *1
    Guide
    *2
    Spring

  1. Engage the 2 springs in the direction indicated by the arrow (2) in the illustration.

    NOTICE:
    Make sure that the springs are securely installed.



2. INSTALL SLIDING ROOF DRIVE CABLE LH


    B300933
  1. Hold down the roof wind deflector panel sub-assembly.



    B300932E01
  1. Using a screwdriver, slide the sliding roof drive cable LH in the direction indicated by the arrow in the illustration to install it.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.



3. INSTALL SLIDING ROOF DRIVE CABLE RH

HINT:
Use the same procedure as for the LH side.



4. INSTALL REAR ROOF DRIP CHANNEL


    B300930E01
  1. Insert the rear roof drip channel in the direction indicated by the arrow (1) in the illustration.

  1. Engage the 2 claws in the direction indicated by the arrow (2) in the illustration to install the rear roof drip channel.



5. ADJUST FULLY CLOSED POSITION


    B300934E01
  1. Using a screwdriver, slide the sliding roof drive cable in either direction indicated by the arrows in the illustration and alignment marks.
    Text in Illustration 
    *1
    Alignment Mark

    HINT:
    Tape the screwdriver tip before use.



6. INSTALL SUNSHADE TRIM SUB-ASSEMBLY


    B300928
  1. Insert the sunshade trim sub-assembly into the sliding roof housing sub-assembly.



    B300926
  1. Install the sliding roof piece sub-assembly LH with the screw.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

    HINT:
    Use the same procedure for the RH side.



7. INSTALL SLIDING ROOF DRIVE GEAR ASSEMBLY


    B300925
  1. Install the sliding roof drive gear assembly with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



    B300924E01
  1. Engage the guide and pin.
    Text in Illustration 
    *1
    Guide
    *2
    Pin

  1. Engage the claw to install the map light bracket.