Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF HOUSING

SLIDING ROOF HOUSING > REMOVAL

for Preparation Click here



1. REMOVE ROOF HEADLINING ASSEMBLY
(Click here)


2. REMOVE SLIDING ROOF SIDE GARNISH LH


    B300917
  1. Disengage the 2 claws and remove the sliding roof side garnish LH.



3. REMOVE SLIDING ROOF SIDE GARNISH RH

HINT:
Use the same procedure as for the LH side.



4. REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY


    B300919
  1. Using a T25 "TORX" socket wrench, remove the 4 screws and sliding roof glass sub-assembly.

    NOTICE:
    To prevent the sliding roof glass and sliding roof drive gear from being displaced, fully close the sliding roof glass (sliding roof drive cable), and then remove the sliding roof glass sub-assembly.



5. REMOVE SLIDING ROOF WEATHERSTRIP
  1. Remove the sliding roof weatherstrip from the sliding roof panel sub-assembly.



6. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

CAUTION:
When storing the curtain shield airbag assembly, keep the airbag deployment side facing upward.

  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



    B296245E01
  1. Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock and disconnect the curtain shield airbag connector.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Airbag Connector
    *3
    Airbag Connector Lock

    NOTICE:
    When disconnecting any airbag connector, take care not to damage the airbag wire harness.

  1. Using a clip remover, remove the 7 pins.



  1. Using 2 screwdrivers, disengage the 2 claws and remove the clip from the body panel as shown in the illustration.


    B296247E01


    Text in Illustration 
    *1
    Body Panel
    *2
    Curtain Shield Airbag Assembly

    HINT:
    Perform the same procedure for the other clips.



  1. While holding the curtain shield airbag assembly, remove the bolt and disengage the 4 clips.


    B296248

    NOTICE:
    When removing the curtain shield airbag assembly, have assistants hold it to prevent it from bending.



    B296250E01
  1. Disengage the hook (A).

  1. Disengage the 3 hooks to remove the curtain shield airbag assembly as shown in the illustration.

  1. Remove the 3 spacers from the curtain shield airbag assembly.



7. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



8. REMOVE SLIDING ROOF HOUSING ASSEMBLY


    B300920
  1. Disengage the claw and disconnect the sliding roof drain hose.

    HINT:
    Use the same procedure for the other 3 sliding roof drain hoses.



  1. Remove the 8 bolts, 6 nuts and sliding roof housing assembly.


    B300922

    NOTICE:
    Do not damage the sliding roof housing assembly or body interior.