TIRE PRESSURE WARNING VALVE > INSTALLATION |
| 1. INSTALL TIRE PRESSURE WARNING VALVE AND TRANSMITTER |
Install a new grommet to the tire pressure warning valve and transmitter.
![]() |
Insert the tire pressure warning valve and transmitter with grommet into the valve installation hole from the inside of the rim so that the printed surface can be seen.
| *a | Printed Surface |
| *b | 7-digit Transmitter ID Number |
![]() |
From the outside of the rim, install the washer onto the tire pressure warning valve and transmitter, and tighten the nut.
| *1 | Tire Pressure Warning Valve and Transmitter |
| *2 | Rim |
| *3 | Grommet |
| *4 | Washer |
| *5 | Nut |
![]() |
Set the wheel onto the mounting machine and install the lower bead. Position the main body of the tire pressure warning valve and transmitter in the area shown in the illustration.
| *1 | Rim |
| *a | Mount Tool of the Mounting Machine |
| *b | 60° |
![]() | Rim Rotating Direction |
![]() | Area for Tire Pressure Warning Valve and Transmitter |
Install the upper bead.
Install the new valve core.
After the tire is inflated, the valve nut may be loose. Retighten the nut to the specified torque.
Check for air leaks with soapy water.
If there is air leakage, push the valve core 2 or 3 times to remove any dirt attached to the valve core. If air continues to leak, replace the grommet, washer and nut.
Install the cap.
| 2. INSTALL FRONT WHEEL |
| 3. INSTALL REAR WHEEL |
| 4. INSPECT TIRES |
Check the tires for wear and proper inflation pressure.
| Tire Size | Front kPa (kgf/cm2, psi) | Rear kPa (kgf/cm2, psi) |
| P175/65R15 84H | 240 (2.4, 35) | 230 (2.3, 33) |
| P195/50R16 83V | 220 (2.2, 32) | 200 (2.0, 29) |
![]() |
Using a dial indicator, check the runout of the tires.
| 5. REGISTER TRANSMITTER ID |
| 6. INSPECT TIRE PRESSURE WARNING SYSTEM |
| 7. PERFORM INITIALIZATION |