Home › Vehicle Interior › HEATING / AIR CONDITIONING › ECO SWITCH

ECO SWITCH > INSPECTION

for Preparation Click here



1. INSPECT ECO MODE SWITCH (ECO SWITCH ASSEMBLY)


    E230461E09
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    G62-6 (E) - G62-9 (ECU)
    ECO mode switch (eco switch assembly) on
    Below 1 Ω
    G62-6 (E) - G62-9 (ECU)
    ECO mode switch (eco switch assembly) off
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (ECO Mode Switch (Eco Switch Assembly))
    1. If the result is not as specified, replace the ECO mode switch (eco switch assembly).

  1. Check that the switch illuminates.

    1. Apply auxiliary battery voltage to the ion generator switch assembly and check that the switch illuminates.

      OK:
      Tester Connection
      Specified Condition
      Auxiliary battery positive (+) → Terminal 8 (ILL+)
      Auxiliary battery negative (-) → Terminal 7 (ILL-)
      Illuminates

      1. If the result is not as specified, replace the ECO mode switch (eco switch assembly).