Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY

HEADLIGHT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. INSTALL HEADLIGHT ASSEMBLY
  1. Connect each connector.

  1. Engage the 2 clamps.

  1. Install the headlight assembly with the 2 screws and bolt.

    Torque:
    Bolt:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



2. INSTALL FRONT BUMPER ASSEMBLY
(Click here)


3. ADJUST HEADLIGHT AIMING
(Click here)