Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY

HEADLIGHT ASSEMBLY > REASSEMBLY

for Preparation Click here



1. INSTALL HEADLIGHT LENS GASKET
  1. Completely remove the old headlight lens gasket.



    E237693E01
  1. Partially remove the release paper, and cut off a piece of it.
    Text in Illustration 
    *1
    Release Paper
    *2
    Tape
    *3
    Headlight Lens Gasket

  1. Fold the release paper over the tip of a screwdriver and fix it in place with tape.

    HINT:
    Use the release paper that is supplied with the headlight lens gasket.

  1. Using scissors, cut the end of the headlight lens gasket at an angle (45°).



    E237694E01
  1. Set the headlight lens gasket into the groove so that the ends of the gasket are aligned with the bottom of the housing, as shown in the illustration.
    Text in Illustration 
    *a
    10 mm (0.394 in.) or more

  1. Using the screwdriver, completely press the headlight lens gasket into the housing to install it.

  1. After pressing the headlight lens gasket completely, check that the ends overlap for 10 mm (0.394 in.) or more.

    HINT:
    Place the headlight lens gasket along the outside surface and press it in with the screwdriver to roll it into place. Then, set the headlight lens gasket at the center of the groove.



2. INSTALL HEADLIGHT LENS


    E237691
  1. Engage the 8 claws and install the headlight lens to the housing.

    NOTICE:
    1. Check that all the claws are engaged.
    2. Wear rubber gloves when handling the headlight lens.
    3. Do not touch the lens or the aluminum surfaces with bare hands.
    4. If there are fingerprints on the aluminum surfaces, wipe them off with a soft cloth.
    5. If there are fingerprints on the back of the headlight lens, replace the headlight lens.
    6. Do not allow dirt or foreign matter to get on the headlight lens.



    E241096E01
  1. Using a T20H "TORX" driver, install the "TORX" screw.
    Text in Illustration 
    *1
    Screw
    *2
    "TORX" Screw

  1. Install the 4 screws.



3. INSTALL FRONT SIDE MARKER LIGHT BULB
  1. Install the front side marker light bulb to the front side marker light socket.



    E241095
  1. Turn the front side marker light socket with the front side marker light bulb in the direction indicated by the arrow shown in the illustration and install them as a unit.



4. INSTALL CLEARANCE LIGHT BULB
  1. Install the clearance light bulb to the clearance light socket.



    E241093
  1. Turn the clearance light socket with the clearance light bulb in the direction indicated by the arrow shown in the illustration and install them as a unit.



5. INSTALL NO. 2 HEADLIGHT BULB


    E241091
  1. Turn the No. 2 headlight bulb in the direction indicated by the arrow shown in the illustration to install it.

    NOTICE:
    Do not touch the bulb glass.



6. INSTALL NO. 1 HEADLIGHT BULB


    E241089
  1. Turn the No. 1 headlight bulb in the direction indicated by the arrow shown in the illustration to install it.

    NOTICE:
    Do not touch the bulb glass.