WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System) > OPERATION CHECK |
| NOTICE WHEN CHECKING THE FOLLOWING |
Wireless door lock/unlock function:
This wireless door lock control function operates only when the following 3 conditions are met:
There is no key in the ignition key cylinder.
All doors are closed.
The power door lock system is operating normally.
The size of the wireless door lock control operation area differs depending on the situation.
The size of the operation area differs depending on the user and the way the door control transmitter module set sub-assembly is held.
In certain areas, the wireless door lock control function will only operate partially for the operation area, which will be reduced due to the vehicle body shape and the influence of the surrounding environment.
Since the door control transmitter module set sub-assembly uses weak radio waves, strong radio waves or electrical noise in the frequency used by the door control transmitter module set sub-assembly may reduce the size of the operation area and the remote control may not function.
When the transmitter battery is weak, the size of the operation area is reduced and the remote control may not function.
| CHECK WIRELESS DOOR LOCK CONTROL FUNCTIONS |
Make sure that the vehicle is in an area that allows the wireless control function to operate.
Check basic functions.
Check that all doors lock when the lock switch is pressed.
Check that the driver door unlocks when the unlock switch is pressed once, and unlocks all doors when pressed twice within 5 seconds.
Check the chattering prevention function.
Check that the corresponding operation occurs only once and is not repeated continuously while the switch is held. However, when the switch is operated repeatedly at 1-second intervals, check that the corresponding operation is carried out.
Check the automatic locking function.
Check that the doors relock automatically as long as none of the doors have been opened or all doors have not been locked within approximately 60 seconds after all doors are unlocked by pressing the unlock switch.
Check that the automatic locking function does not operate when any door has been opened within approximately 60 seconds of unlocking the doors by pressing the unlock switch.
Check that the automatic locking function does not operate when all doors have been locked manually (such as using key linked operation, or by pressing the lock switch) within approximately 60 seconds of unlocking the doors by pressing the unlock switch.
Check the switch operation fail-safe function.
Check that the doors cannot be locked/unlocked when operating a switch on an unregistered door control transmitter module set sub-assembly, but the doors can be locked/unlocked when operating a switch on the registered door control transmitter module set sub-assembly.
Check that the doors cannot be locked/unlocked when a switch is operated with the key inserted into the ignition key cylinder. This does not apply when registering the identification code.
Check the repeat function.
Check that all doors attempt to automatically lock once again 1 second after the lock switch has been pressed while the driver door control knob is being held in the unlock position.
Check the answer-back (hazard warning light) function.
When the lock switch is pressed, check that the hazard warning lights flash once simultaneously with the locking operation of all doors.
When the unlock switch is pressed once, check that the hazard warning lights flash twice simultaneously with the unlocking operation of the driver door.
Check the door lock stop function that operates when a door is open/ajar
With a door open or ajar, check that the doors cannot be locked when the lock switch is operated.
Check the remote panic function.
Check that the horn sounds, the headlights, taillights and hazard lights flash and the interior lights remain on (when the light switch is turned to the door position) for 60 seconds by the theft alarm function, when the panic switch is held down for 0.8 seconds or more. Also, check that the horn stops sounding and the lights stop flashing when any switch of the electrical key transmitter sub-assembly is pressed.
Check the illuminated entry function (Click here).