Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH

WIPER SWITCH > REMOVAL

for Preparation Click here



1. REMOVE LOWER STEERING COLUMN COVER

NOTICE:
Removing the lower steering column cover in the incorrect order will cause the parts to break.

  1. Release the tilt lever, and fully extend and lower the steering column.

  1. Turn the steering wheel assembly to the left and remove the screw.



    E237550
  1. Turn the steering wheel assembly to the right and remove the screw.

  1. Remove the screw from the lower portion of the lower steering column cover.



    E237551
  1. Disengage the 4 claws and remove the lower steering column cover.



2. REMOVE UPPER STEERING COLUMN COVER


    E237552
  1. Disengage the 2 claws and remove the upper steering column cover.



3. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
  1. Turn the steering wheel assembly to the right.



    E237553E01
  1. Disconnect each connector.
    Text in Illustration 
    *1
    Screwdriver

  1. Disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.

    NOTICE:
    If the claw is pushed with excessive force, it may break.