Home › Vehicle Exterior › WIPER / WASHER › FRONT WIPER MOTOR

FRONT WIPER MOTOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT WIPER ARM HEAD CAP


    E237523E01
  1. Using a screwdriver, disengage the 3 claws and remove the front wiper arm head cap.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure for the RH side and LH side.



2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH


    E237525
  1. Remove the nut and front wiper arm and blade assembly LH.



3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH


    E237526
  1. Remove the nut and front wiper arm and blade assembly RH.



4. REMOVE FRONT FENDER TO COWL SIDE SEAL LH


    E237529
  1. Disengage the 2 clips.



    E237527E01
  1. Separate the double-sided tape.
    Text in Illustration 
    *1
    Double-sided Tape
    *2
    Clip

  1. Disengage the 3 guides, and remove the front fender to cowl side seal LH as shown in the illustration.

    NOTICE:
    To avoid damaging the clip when removing the front fender to cowl side seal, slide the cowl to disengage the guide from the clip with the clip engage to the vehicie.

  1. Disengage the clip from the vehicle.



5. REMOVE FRONT FENDER TO COWL SIDE SEAL RH

HINT:
Use the same procedure as for the LH side.



6. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY


    E237530
  1. Remove the 2 clips.

  1. Disconnect the washer hose.



  1. Disengage the 5 claws and 3 guides as shown in the illustration.


    E237531



  1. Disengage the 8 guides and pull out the cowl top ventilator louver sub-assembly as shown in the illustration.


    E237533



7. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY


    E237535
  1. Disengage the clamp.

  1. Remove the 2 bolts.



    E237536E01
  1. Disengage the motor grommet and remove the windshield wiper motor and link assembly as shown in the illustration.
    Text in Illustration 
    *1
    Motor Grommet

    NOTICE:
    Be careful not to damage the windshield when removing the windshield wiper motor and link assembly.



    E237538
  1. Disconnect the connector.



8. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY


    E237539E01
  1. Using a screwdriver, separate the windshield wiper link No. 2 rod from the windshield wiper link pivot of the windshield wiper motor and link assembly as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Windshield Wiper Link No. 2 Rod
    *a
    Windshield Wiper Link Pivot

    HINT:
    Tape the screwdriver tip before use.



    E237541E01
  1. Using a screwdriver, separate the windshield wiper link No. 1 rod from the windshield wiper crank pivot of the windshield wiper motor and link assembly as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Windshield Wiper Link No. 1 Rod
    *a
    Windshield Wiper Crank Pivot



    E237543
  1. Remove the 3 bolts and windshield wiper motor assembly from the windshield wiper link assembly.