Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK

REAR DOOR LOCK > INSPECTION

for Preparation Click here



1. INSPECT REAR DOOR LOCK ASSEMBLY LH


    B164415E13
  1. Check the operation of the door lock motor.

    1. Apply auxiliary battery voltage and check the operation of the rear door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Auxiliary battery positive (+) → Terminal 4 (L)
      Auxiliary battery negative (-) → Terminal 1 (UL)
      Locks
      Auxiliary battery positive (+) → Terminal 1 (UL)
      Auxiliary battery negative (-) → Terminal 4 (L)
      Unlocks

      Text in Illustration 
      *a
      Component without harness connected
      (Rear Door Lock Assembly LH)
      *b
      Unlock
      *c
      Lock
      If the result is not as specified, replace the rear door lock assembly LH.



    B164415E13
  1. Check the resistance of the unlock detection switch. (w/ Smart Key System)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      6 (LSSR) - 9 (E)
      Locked
      10 kΩ or higher
      Unlocked
      Below 1 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (Rear Door Lock Assembly LH)
      *b
      Unlock
      *c
      Lock
      If the result is not as specified, replace the rear door lock assembly LH.



2. INSPECT REAR DOOR LOCK ASSEMBLY RH


    B164416E11
  1. Check the operation of the rear door lock motor.

    1. Apply auxiliary battery voltage and check the operation of the rear door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Auxiliary battery positive (+) → Terminal 4 (L)
      Auxiliary battery negative (-) → Terminal 1 (UL)
      Locks
      Auxiliary battery positive (+) → Terminal 1 (UL)
      Auxiliary battery negative (-) → Terminal 4 (L)
      Unlocks

      Text in Illustration 
      *a
      Component without harness connected
      (Rear Door Lock Assembly RH)
      *b
      Unlock
      *c
      Lock
      If the result is not as specified, replace the rear door lock assembly RH.



    B164416E11
  1. Check the operation of the unlock detection switch. (w/ Smart Key System)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      6 (LSSR) - 9 (E)
      Locked
      10 kΩ or higher
      6 (LSSR) - 9 (E)
      Unlocked
      Below 1 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (Rear Door Lock Assembly RH)
      *b
      Unlock
      *c
      Lock
      If the result is not as specified, replace the rear door lock assembly RH.