Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR

OUTER REAR VIEW MIRROR > INSTALLATION

for Preparation Click here



1. INSTALL OUTER MIRROR COVER
  1. Engage the 5 claws to install the outer mirror cover.



    B307753
  1. Push the outside part of the outer mirror assembly and tilt it as shown in the illustration.



2. INSTALL OUTER MIRROR
  1. w/ Heater:

    1. Connect the 2 connectors and engage the guide.



    B307754
  1. Engage the 4 claws to install the outer mirror.

    NOTICE:
    Do not push in the outer mirror with excessive force. Doing so may break the mirror surface.



3. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER
  1. Engage the claw to install the outer rear view mirror assembly with cover with the 3 screws.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

  1. Connect the connector.



4. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    B307126E02
  1. Connect the front door lock remote control cable assembly and front door inside locking cable assembly to the front door inside handle sub-assembly.
    Text in Illustration 
    *1
    Front Door Inside Locking Cable Assembly
    *2
    Front Door Lock Remote Control Cable Assembly



    B307169
  1. Engage the 8 clips.



    B307081
  1. Install the front door trim board sub-assembly with the 3 screws.



    B307127
  1. Engage the claw and close the cover.



5. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
  1. Connect the connector.



    B307078
  1. Engage the 4 guides and 10 claws to install power window regulator master switch assembly with front door armrest base panel.



6. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
  1. Connect the connector.



    B307079
  1. Engage the 4 guides and 10 claws to install power window regulator switch assembly with front door armrest base panel.