Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR

OUTER REAR VIEW MIRROR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)


    B307078
  1. Disengage the 10 claws and 4 guides.

  1. Disconnect the connector and remove the power window regulator master switch assembly with front door armrest base panel.



2. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)


    B307079
  1. Disengage the 10 claws and 4 guides.

  1. Disconnect the connector and remove the power window regulator switch assembly with front door armrest base panel.



3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    B307080E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and open the cover.
    Text in Illustration 
    *1
    Protective Tape



    B307081
  1. Remove the 3 screws.



    B307082
  1. Disengage the 8 clips and remove the front door trim board sub-assembly as shown in the illustration.



    B307083E01
  1. Disconnect the front door lock remote control cable assembly and front door inside locking cable from the front door trim board sub-assembly.
    Text in Illustration 
    *1
    Front Door Inside Locking Cable Assembly
    *2
    Front Door Lock Remote Control Cable Assembly



4. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER


    B307652
  1. Disconnect the connector.

  1. Remove the 3 screws.

  1. Disengage the claw and remove the outer rear view mirror assembly with cover.



5. REMOVE OUTER MIRROR


    B307653E01
  1. Push the upper part of the outer mirror surface and tilt it.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Moulding Remover

  1. Apply protective tape to the lower of the outer rear view mirror assembly with cover.

  1. Using a moulding remover, disengage the 2 claws at the lower part of the outer rear view mirror assembly with cover, and separate the outer mirror.

    NOTICE:
    Do not pull the outer mirror with excessive force. Doing so may cause the actuator to come off or break the mirror surface.

  1. Push the lower part of the mirror surface and tilt it.



    B307654E01
  1. Apply protective tape to the upper of the outer rear view mirror assembly with cover.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Moulding Remover

  1. Using a moulding remover, disengage the 2 claws at the upper part of the outer rear view mirror assembly with cover, and remove the outer mirror.

    NOTICE:
    Do not pull the outer mirror with excessive force. Doing so may cause the actuator to come off or break the mirror surface.



  1. w/ Heater:



      B302271
    1. Disengage the guide and disconnect the 2 connectors to remove the outer mirror.



6. REMOVE OUTER MIRROR COVER


    B307655
  1. Push the outside part of the outer mirror assembly and tilt it as shown in the illustration.



    B307656
  1. Disengage the claw at bottom of the outer rear view mirror assembly.



    B307657
  1. Disengage the 4 claws and remove the outer mirror cover.