WIRELESS DOOR LOCK CONTROL SYSTEM (w/ Smart Key System) > DIAGNOSIS SYSTEM |
| DESCRIPTION |
| CHECK DLC3 |
Check the DLC3 (Click here).
| INSPECT AUXILIARY BATTERY VOLTAGE |
Measure the vehicle auxiliary battery voltage with the power switch off.
| SELF-DIAGNOSTIC MODE (USING TECHSTREAM) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Smart Key / Utility / Wireless Door Lock Diagnosis Mode.
Proceed to the next step in accordance with the prompts on the Techstream screen.
![]() |
Check that the system has switched to self-diagnostic mode by checking the wireless door lock buzzer output pattern.
Check the diagnostic outputs when an electrical key transmitter sub-assembly switch is held down. The diagnostic outputs can be checked by the interior light and wireless door lock buzzer patterns.

| Wireless Door Lock Buzzer Output | Suspected Area |
| A | Normal (No malfunction) |
| B | Register wireless code |
| C | Wave interference or malfunction of a related component |