Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System)

WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System) > DIAGNOSIS SYSTEM

for Preparation Click here



CHECK DLC3
  1. Check the DLC3 (Click here).


INSPECT AUXILIARY BATTERY VOLTAGE
  1. Measure the vehicle auxiliary battery voltage with the ignition switch off.

    Standard Voltage:
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the auxiliary battery.


SELF-DIAGNOSTIC MODE (USING TECHSTREAM)
  1. Connect the Techstream to the DLC3

  2. Turn the Ignition switch ON (IG)

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Main Body / Wireless Diagnosis Mode.

  5. Proceed to the next step in accordance with the prompts on the Techstream screen.



  6. B220865E09
  7. Check that the system has switched to self-diagnostic mode by checking the interior light output pattern.



  8. Check the diagnostic outputs when a door control transmitter module set sub-assembly switch is held down. The diagnostic outputs can be checked by the interior light patterns.


    B163380E41

    Result 
    Interior Light Output
    Suspected Area
    A
    Normal (No malfunction)
    B
    Register wireless code
    C
    Wave interference or malfunction of a related component