Home › Engine / Hybrid System › 1NZ-FXE STARTING › IGNITION SWITCH

IGNITION SWITCH > REMOVAL

for Preparation Click here



1. REMOVE STEERING COLUMN ASSEMBLY
(Click here).


2. REMOVE UPPER STEERING COLUMN WITH SWITCH BRACKET ASSEMBLY
  1. Secure the steering column assembly in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Using a drill, drill a hole in the steering lock set bolt, to insert a screw extractor.



    C232526
  1. Using the screw extractor, remove the steering lock set bolt and remove the upper steering column with switch bracket assembly.



3. REMOVE IGNITION OR STARTER SWITCH ASSEMBLY


    A255481
  1. Disengage the 2 claws and remove the ignition or starter switch assembly.