Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › WATER PUMP WITH MOTOR

WATER PUMP WITH MOTOR > INSTALLATION

for Preparation Click here



1. INSTALL HV WATER PUMP BRACKET SUB-ASSEMBLY
  1. Install the HV water pump bracket sub-assembly with the 2 bolts.

    Torque:
    20 N*m{ 199 kgf*cm , 14 ft.*lbf }

  1. Connect the clamp.



2. INSTALL INVERTER WATER PUMP ASSEMBLY
  1. Install the inverter water pump assembly with the 3 bolts.

    Torque:
    6.1 N*m{ 62 kgf*cm , 54 in.*lbf }

    NOTICE:
    Do not hold the inverter water pump assembly by the connector terminals when removing or installing it.

  1. Connect the connector.



    A266740E01
  1. Connect the 2 water hoses.
    Text in Illustration 
    *1
    Clamp A
    *2
    Clamp B
    *a
    Alignment mark (White)
    *b
    Alignment Mark (Yellow)
    *c
    Rib
    *d
    90°
    *e
    45°

    NOTICE:
    1. Connect the water hoses securely up to the rib of the inverter water pump assembly.
    2. Make sure to align the alignment marks of the hoses with the ribs of the inverter water pump assembly.
    3. Do not remove the pieces of cloth from the pipes and disconnected hoses until installation to prevent foreign matter from entering the inverter water pump and cooling system.
    4. Make sure that the clamp A is positioned as shown in the illustration.

    HINT:
    Clamp B can be oriented in any angle.



3. INSTALL INVERTER BRACKET ASSEMBLY

CAUTION:
Wear insulated gloves.

  1. Temporarily install the inverter bracket assembly with the 4 bolts.



    A268009E01
  1. Tighten the 4 bolts in the sequence shown in the illustration.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }

  1. Connect the earth wire with the bolt.

    Torque:
    8.4 N*m{ 85 kgf*cm , 74 in.*lbf }

  1. Install the inverter reservoir tank assembly with the 2 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



    A268006
  1. Connect the 2 wire harness clamps.



    A268005
  1. Connect the motor cable protector with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



4. INSTALL INVERTER WITH CONVERTER ASSEMBLY
(Click here).