OIL AND OIL FILTER > REPLACEMENT |
| 1. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the oil pan drain plug and gasket, and drain the oil into a container.
Clean and install the oil drain plug with a new gasket.
| 2. REMOVE OIL FILTER SUB-ASSEMBLY |
Using SST, remove the oil filter.
| 3. INSTALL OIL FILTER SUB-ASSEMBLY |
Check and clean the oil filter installation surface.
Apply clean engine oil to the gasket of a new oil filter.
Lightly screw the oil filter into place by hand. Tighten it until the gasket contacts the seat.
Using SST, tighten the oil filter.
Depending on the work space available, choose from the following:
| 4. ADD ENGINE OIL |
Add new oil.
| Oil Grade | Oil Viscosity (SAE) |
| ILSAC multigrade engine oil | 0W-20 |
| Item | Standard Condition |
| Drain and refill with oil filter change | 3.7 liters (3.9 US qts, 3.3 Imp. qts) |
| Drain and refill without oil filter change | 3.4 liters (3.6 US qts, 3.0 Imp. qts) |
| Dry fill | 4.1 liters (4.3 US qts, 3.6 Imp. qts) |
Install the oil filler cap.
| 5. INSPECT FOR OIL LEAK |