STEERING LOCK SYSTEM > DTC CHECK / CLEAR |
| CHECK FOR DTC (POWER MANAGEMENT CONTROL ECU) |
Turn the power switch off.
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Power Source Control / Trouble Codes.
Check for DTCs.
| CHECK FOR DTC (MAIN BODY ECU) |
Turn the power switch off.
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Trouble Codes.
Check for DTCs.
| CHECK FOR DTC (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)) |
Turn the power switch off.
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Smart Key / Trouble Codes.
Check for DTCs.
| CLEAR DTC (POWER MANAGEMENT CONTROL ECU) |
Turn the power switch off.
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Power Source Control / Trouble Codes.
Clear the DTCs.
| CLEAR DTC (MAIN BODY ECU) |
Turn the power switch off.
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Trouble Codes.
Clear the DTCs.
| CLEAR DTC (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)) |
Turn the power switch off.
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Smart Key / Trouble Codes.
Clear the DTCs.