STOP LIGHT SWITCH > ON-VEHICLE INSPECTION |
| 1. INSPECT STOP LIGHT SWITCH ASSEMBLY |
![]() |
Disconnect the A65 connector from the stop light switch assembly.
Measure the voltage according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A65-1 (B) - A65-3 (GND) | Ignition switch off | 11 to 14 V |
| A65-5 (B) - A65-3 (GND) | Ignition switch ON (IG) | 11 to 14 V |
| *a | Front view of wire harness connector (to Stop Light Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A65-3 (GND) - Body ground | Always | Below 1 Ω |
![]() |
Reconnect the A65 connector to the stop light switch assembly.
Measure the voltage according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A65-2 (OUT) - A65-3 (GND) | Power switch off, brake pedal not depressed | Below 1 V |
| A65-2 (OUT) - A65-3 (GND) | Power switch off, brake pedal depressed | 11 to 14 V |
| A65-4 (L) - A65-3 (GND) | Power switch on (IG), brake pedal not depressed | Below 1 V |
| A65-4 (L) - A65-3 (GND) | Power switch on (IG), brake pedal depressed | 11 to 14 V |
| *a | Component with harness connected (Stop Light Switch Assembly) |