After Engine Stop
All of the following conditions are met
| -
|
Time after engine start
| 10 seconds or more
|
Auxiliary battery voltage
| 10.5 V or higher
|
Engine coolant temperature at ECM started by internal engine off timer
| -40°C (-40°F) or higher
|
Engine coolant temperature before engine stop
| 70°C (158°F) or higher
|
Time that mass air flow is low before engine stop
| 90 seconds or more
|
Accumulated mass air flow amount before engine stop
| 2882 g or more
|
Key-off duration
| 30 minutes
|
Mass air flow meter circuit fail (P0102, P0103)
| Not detected
|
Engine coolant temperature sensor circuit fail (P0115, P0117, P0118)
| Not detected
|
Intake air temperature sensor circuit fail (P0112, P0113)
| Not detected
|
Engine water pump circuit fail (P261B, P261C, P261D)
| Not detected
|
Soak timer fail (P2610)
| Not detected
|
After Cold Engine Start
All of the following conditions are met
| -
|
Key-off duration
| 5 hours or more
|
Time after engine start
| 10 seconds or more
|
Engine coolant temperature
| 70°C (158°F) or higher
|
Accumulated mass air flow amount
| 2882 g or more
|
Either of the following conditions is met
| 1 or 2
|
1. Duration while engine load is low
| 90 seconds or more
|
2. Duration while engine load is high
| 10 seconds or more
|
Mass air flow meter circuit fail (P0102, P0103)
| Not detected
|
Engine coolant temperature sensor circuit fail (P0115, P0117, P0118)
| Not detected
|
Intake air temperature sensor circuit fail (P0112, P0113)
| Not detected
|
Engine water pump circuit fail (P261B, P261C, P261D)
| Not detected
|
Soak timer fail (P2610)
| Not detected
|